This index is designed to cover the declassified and unclassified work of the University of Rochester Atomic Energy Project from its beginning in 1943 until July 1960. It contains titles of the work described in Manhattan District and Atomic Energy Commission reports as well as of material published in books and journals.

Most laboratory data on simulated nuclear weapon thermal pulses can be compared only indirectly with the results from field studies. To over-come this handicap, data of the type which could be obtained in field experiments were sought Burns from the following radiant exposure-simulated nuclear weapon pulse combinations were produced: (1) 5 cal/sq cm - 20 KT, ho KT, 100 KT, 1000 KT; (2) 10 cal/sq cm - 20 KT, 40 KT, 100 KT, 1000 KT, 10,000 KT; (3) 15 cal/sq cm - 100 KT, 1000 KT, 10,000 KT; and (4) 20 cal/sq cm - 100 KT, 1000 KT, 10,000 KT. With most of the combinations studied, a moderately wide range of burn severity occurred within the sixteen replications of a single exposure-pulse combination. Radiant exposures of 10 cal/sq cm resulted in nearly the same depth of damage with thermal pulses simulating 20 KT, 40 KT, 100 KT and 1000 KT weapons. Pulses simulating 100 KT, 1000 KT, and 10,000 KT weapons had little influence on burns produced by exposures of 15 cal/sq cm. With the 5 cal/sq cm exposure, maximum damage resulted from the use of a 20 KT pulse. On the other hand, less damage occurred from 20 cal/sq cm with the 100 KT pulse than with either 1000 KT or 10,000 KT pulses. Except for the 5 cal/sq cm exposure, the results are contrary to some earlier predictions of the effects of nuclear weapons.

A total of 2519 annotated references to the unclassified report literature is presented. Subjects covered under heat transfer and fluid flow include radioinduced heating; boiling; boiler, evaporators, pump, and heat exchanger design; hydrodynamics; coolants and their properties; thermal and flow instrumentation; high temperature materials; thermal properties of materials; and thermal insulation. Subjects covered less completely include thermodynamics; aerodynamics; high temperature corrosion; corrosion specific to heat transfer systems; erosion; mass transfer; corrosion film formation and effects; coolant processing and radioactivity; radiation effects of heat transfer materials; and pertinent data of thermonuclear processes. Subject, report number availability, and author indexes are given.